Archives: Services

You should be able to apply the MSM routine when approaching pedestrian crossings while anticipating the actions of pedestrians.

When you are driving along the road you should be looking well ahead. When you see a crossing ahead you must assess the situation. If you cannot see each end of the crossing clearly you should assume that there is someone about to cross. Pedestrians who are young, elderly, disabled or people with prams all need special consideration. If they are waiting to use a Zebra crossing you should stop and let them cross even though they have not yet put their foot on the crossing.

You must apply the MSM routine on approach to any hazard.

The first thing you must do is to check your mirrors, consider any signal that might be necessary. In this instance the signal part means the brake lights. On a Zebra crossing an arm signal for slowing down or stopping can be used, this is particularly useful if you decide to give way to any pedestrians who are obviously waiting to cross but who have not yet put a foot onto the crossing or if you have a vehicle following close behind. An arm signal has the advantage of being visible to following and oncoming traffic and pedestrians at the crossing and makes your intentions absolutely clear.

The next part of the routine is the manoeuvre, in this case the correct level of speed on approach. You must approach the crossing ready, willing and able to stop if necessary, so your speed must be reduced to enable you to do this. You must not approach the crossing so fast that you are not able to stop safely but on the other hand you must not drive needlessly slowly either. Sometimes simply easing off the gas pedal will be sufficient to allow a pedestrian more time to cross before you reach the crossing. If you have stopped to allow a pedestrian to cross on a Zebra crossing and they appear hesitant and undecided give them time to make up their mind. Do not beckon them on. When you enter the zigzag area of any crossing you must not overtake the leading vehicle or the vehicle that has stopped at the crossing.

When you are stopped at a zebra crossing you should wait until any pedestrians are clear, however if the crossing has a central island then it forms two separate crossings and you can move off if it is safe to do so when pedestrians are on the other half of the road. However you must watch for pedestrians who may cross from your right and walk straight out onto your side of the crossing. Remember: You must not park on a crossing or in the area covered by the zigzag lines. You must not overtake the moving vehicle nearest the crossing or the vehicle nearest the crossing which has stopped to give way to pedestrians

There are 5 different types of pedestrian crossing: – Zebra, Pelican, Puffin, Toucan and Pegasus.

Zebra Crossing

A Zebra crossing is a path across a road marked with black and white stripes where pedestrians may cross. They have NO traffic lights. Drivers approaching a Zebra cosssing are made aware of the crossing because of its black and white poles with flashing yellow beacons and zigzag road markings. As you approach a zebra crossing look out for people waiting to cross and be ready to slow down or stop to let them cross. Use your mirrors frequently on approach so you know exactly what following traffic is up to and stop before the white dotted line – not after it. If you have time, give an arm signal for slowing down. This lets the pedestrians know what you are doing and also warns other vehicles that you are stopping. You MUST give way when someone has moved onto a crossing. Do not wave people across; this could be dangerous if another vehicle is approaching and don’t flash your headlights! Try and make eye contact with anyone waiting. This helps reassure them that they have been seen. Be aware of pedestrians approaching from the side of the crossing after you have stopped.

Pelican Crossing

These are signal-controlled crossings operated by pedestrians. Drivers approaching a Pelican crossing are made aware of the crossing because of its traffic lights and zigzag road markings. Iron railings are usually used to stop pedestrians entering the road away from the crossing. Plan what you are going to do before you get there. If, for example, the lights are on green for some time and people are waiting at the crossing, be prepared to slow down as they could turn to red! Use your mirrors frequently on approach so you know exactly what following traffic is up to and stop on the white line – not after it! These are signal-controlled crossings where flashing amber follows the red ‘Stop’ light. You MUST stop when the red light shows. When the amber light is flashing, you MUST give way to any pedestrians on the crossing. If the amber light is flashing and there are no pedestrians on the crossing, you may proceed with caution. After the lights start flashing, watch out for people making a last-minute dash. Be prepared to let them cross but do not wave others onto the crossing.

Puffin Crossing

These differ from Pelican crossings as there is no flashing green figure phase. Infa-red cameras are attached to traffic lights which extend the time drivers see red so elderly or disabled people aren’t at risk from oncoming traffic. The new ‘smart’ system also uses heat sensors to tell if pedestrians are waiting on the pavement, and can even override the red light shown to drivers if they’ve already got to the other side. It has reduced delays to motor vehicles, and improved crossing conditions for elderly and disabled persons by automatically varying the crossing times. Drivers approaching a Puffin crossing are made aware of the crossing because of its traffic lights and zigzag road markings. Iron railings are usually used to stop pedestrians entering the road away from the crossing. The lights have no flashing amber phase, so the lights just change like a normal traffic light at a junction.

Toucan Crossing (Two-Can Cross)

On Toucan crossings cyclists are permitted to ride across the road. Drivers approaching a Toucan crossing are made aware of the crossing because of its traffic lights and usually zigzag road markings (zigzag markings are not always present). Iron railings are usually used to stop pedestrians and cyclists entering the road away from the crossing. The lights have no flashing amber phase, so the lights just change like a normal traffic light at a junction.

Pegasus Crossing

The Pegasus crossing is usually used outside race courses or areas where horses are trained. They appear to be very popular in Scotland. The Pegasus crossing is similar to any other light controlled crossing, but in addition to provision for pedestrians (as at a Puffin Crossing) and/or cyclists (as at a Toucan crossing) the Pegasus crossing makes special provision for horses. Drivers approaching a Pegasus crossing are made aware of the crossing because of its traffic lights and zigzag road markings .Iron railings are usually used to stop pedestrians and horses entering the road away from the crossing. From a drivers point of view, the crossing works in the same way as ordinary traffic lights. For riders there is a ‘high level’ push button to operate the crossing. Because this is placed on the traffic–light support, the horse has to come very close to the road in order for the button to be pressed … So be careful!

The Driving Test

The examiner on the driving test will expect you to:-

• Demonstrate consideration and courtesy for pedestrians.
• Stop at Pelican, Puffin, Toucan and Pegasus Crossings if the lights are red.
• Give way to pedestrians at Pelican Crossings if the lights are flashing amber.
• Slow down and stop at Zebra Crossings if anyone is crossing or waiting to cross.
• Control your speed on approach to Pedestrian Crossings.
• Move off, after looking carefully to ensure it is safe.

 You should be able to apply the MSM routine to join and leave a roundabout.

On approaching a roundabout take notice and act on all the information available to you, including traffic signs, traffic lights and lane markings which direct you into the correct lane.

Of course all roundabouts are different but generally the following rules apply:

• To Turn Left – Signal left and approach in the left-hand lane keep to the left on the roundabout and continue signaling left to leave.
• To go straight on – If there are no markings on the road you must use the left lane and stay in this lane until you need to exit the roundabout, signal left after you have passed the exit before the one you want.
• To Turn Right – Signal right and approach in the right–hand lane, keep to the right on the roundabout until you need to change lanes to exit the roundabout. Signal left after you have passed the exit before the one you want.

Approaching a roundabout

Remember to use the MSM routine at all stages and decide as early as possible which exit you need to take, give an appropriate signal. Slow up sufficiently and make sure you are in the correct lane a good distance from the roundabout. Adjust your speed and position to fit in with traffic conditions.

If you get your approach speed and gear right you can merge in with the traffic most times without stopping.

Always be aware of the speed and position of all the traffic around you. Don’t worry if you have to stop when you reach the roundabout. When it’s clear, move off smoothly, don’t rush, keep using the mirrors, and above all, stay calm. Once you are on the roundabout maintain a reasonable speed, especially when you are in the right–hand lane, failure to do so may result in other drivers passing on the nearside.

Watch out for vehicles already on the roundabout; be aware they may not be signaling correctly or at all.

Always keep an eye on the vehicle in front as you’re about to emerge. Don’t assume the driver won’t have to stop while you’re still looking right. Many rear end collisions happen this way. Make sure the vehicle has actually moved away.

Mini Roundabouts

Approach these in the same way as a normal roundabout, but remember there is less space and time to signal and manoeuvre. Vehicles coming towards you may want to turn right. Be sure any vehicle on the roundabout is going to leave before you join the roundabout yourself. Remember, you don’t always have time to signal when leaving a mini, but do check your left mirror.

Be aware of drivers that are using it for a ‘U turn’.

Multiple Mini roundabouts

At some complex junctions, there may be a series of mini-roundabouts at the intersections. Treat each roundabout separately and give way to traffic from the right. When negotiating a number of junctions within a short distance of each other, choose a lane that puts you in the correct position for the next one.

In all cases watch out for and give plenty of room to:

• Pedestrians – who may be crossing your exit.
• Traffic – crossing in front of you on the roundabout, especially vehicles intending to leave by the next exit or traffic which may be straddling lanes or positioned incorrectly.
• Motorcyclists, cyclists and horse riders – who may stay in the left-hand lane and signal right if they intend to continue round the roundabout.
• Long vehicles – (including those towing trailers) they may have to take a different course approaching. Watch out for their signals.

The Driving Test

The examiner on the driving test will expect you to:-

• Use the MSM routine
• Position correctly and adjust your speed
• Choose the correct lane where there are lane markings
• Watch out for motorcyclists, cyclists and pedestrians
• Take effective observations
• Assess the speed of traffic

Preparation

Assume that the engine is running and that you want to move off the first thing that you have to do is prepare the car, this consists of putting the clutch pedal down to the floor and selecting first gear, this is the gear that you will use for moving off on a flat road or uphill. The next thing that you must do is to set the gas; this means pressing the gas pedal slightly and holding it still, this generates sufficient power to move. Listen to the engine noise. Don’t let the engine roar! Bring the clutch up until the sound of the engine drops slightly and then keep both feet still (this is called the ‘biting point’).

Observation

You must check the road ahead and behind through all mirrors. Be prepared to wait if the road is not clear. You must also check your blindspots just as you are about to move off. As well as deciding whether it is safe to move off you must ask yourself whether it is necessary to give a signal before moving. If there is not the slightest chance of any-one being affected by you moving off, including oncoming traffic and pedestrians, there is no point in signaling. But if there is any sign of life anywhere near you, why risk it?

Move

To enable the vehicle to move off smoothly the handbrake must be taken off, and then gently increase the gas and lift the clutch up slightly, the car will begin to move off as this is done. If the car doesn’t move let the clutch up a little more. Move away only if it is safe. When the car is moving you will have to gently steer away from the kerb to the driving position about 1 metre from the kerb. To increase your speed, press the gas pedal gently and gently raise the clutch and take your foot away from the clutch pedal. You will need to change into 2nd gear soon after moving away.

Note: You should normally use 1st gear for moving off except when moving off down a steep hill, then it may be best to use 2nd gear

Stopping

When you have to pick a place to stop you must make sure that it is a safe place, you wouldn’t for example park near a junction or blocking an entrance, on a bend or before a hump-back bridge. You must also make sure that it is lawful to park and that there are no restrictions on stopping. There are many places where parking would cause an obstruction to other vehicles or road users.

Once you have selected a safe place to stop then you must use the Mirrors, Signal, Manoeuvre routine. You should never be taken by surprise when you check your mirrors because through regular checks as you drive along you will have a good idea about what is behind you. Just as important when stopping is to use the exterior mirrors with particular emphasis on the nearside mirror as there might be a cyclist in the ‘blindspot‘ area.

Having checked the mirrors and deciding that it is safe to stop you must then decide if you need to give a signal. A signal should be given if it will help or warn other road users, remember that signal will also help oncoming vehicles and any pedestrians as well as vehicles approaching from behind. A signal should always be given in good time but you must avoid giving any signal which may be misleading, for example if there is a road on the left prior to the place where you intend to stop the signal would have to be left until you have passed it.

The Manoeuvre part of the sequence involves slowing down at first by coming off the gas pedal and beginning to steer into position for stopping then use the footbrake progressively to bring the car to a stop in the proper place and close to the kerb. Just before the car stops the clutch pedal must be pushed right down to the floor to prevent the car engine stalling. When the car has stopped keep both feet still until you have applied the handbrake and moved the gear level into the neutral position.

The Driving Test

The examiner on the driving test will expect you to:-

• Move off safely and under control on a level road, from behind a parked vehicle and on a gradient
• Use the MSM routine
• Check your blindspot for traffic and pedestrians
• Make balanced use of the accelerator, clutch, brakes and steering
• Use the appropriate gear